Custom Boat Manual

Models › Sea Ray

Sea Ray 370 Sedan Bridge

Built 1991–1997 by Sea Ray Boats

Own one? Keep her maintenance, manuals and checklists here — free Shopping? Find the right used boat

About the Sea Ray 370 Sedan Bridge

Researched from public sources for this model. Any individual boat may have been modified or repowered — confirm before relying on any figure.

Illustration of a Sea Ray 370 Sedan Bridge
Illustration, not a photo of this model. AI-generated illustration of a typical flybridge motor yacht.
Built
1991–1997
Builder
Sea Ray Boats
Length
40.83 ft
Beam
12.33 ft
Draft
2.58 ft
Displacement
14,600 lb
Hull
fiberglass
Hull / keel
planing
Propulsion
inboard
Fuel
250 gal
Water
70 gal
Holding
20 gal
Stern thruster
none

Sources disagree on engines[MerCruiser].hp — left blank rather than guessed.

Solid fiberglass deep-V (21 deg) with prop pockets and side exhausts. Hull length 36.8 ft; LOA includes platform. Lower helm optional. Narrow side decks.

Known problems for this model

No well-sourced problem reports found yet.

Engines & parts

MerCruiser 5.0 (305) / 5.7 (350) V8 gas parts: good

Factory standard engine — you entered “MerCruiser V8 gas inboard”

GM small-block Chevrolet base engines, so internal parts are everywhere. Marine exhaust manifolds and risers for 1983–2002 small blocks are sold by many aftermarket makers (Sierra, Barr, Osco and others) through Power Boat Supply, Hardin Marine, Basic Power Industries and similar stores; Mercury sells genuine parts through dealers.

Parts sources: Power Boat Supply, Hardin Marine, Basic Power Industries

Common problems (2)
  • Manifold/riser failure and water in cylinders exhaust
    Cast-iron manifolds and risers rust internally or their gaskets fail, letting water back into the cylinders; small amounts cause hard starting and rough running, large amounts hydrolock and wreck the engine. Service roughly every 7 years in fresh water and about 5 in salt.
    powerandmotoryacht.com · forums.iboats.com · justanswer.com
  • Overheating from scaled manifolds cooling
    Rust and scale inside the manifolds restrict cooling flow and cause overheating under load.
    powerandmotoryacht.com
Model sources (1)

hmy.com

Other Sea Ray models

Researched from public sources. Spotted an error? The sources are listed above — tell us what they got wrong.